Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Gallery Index & Tech Ref
Goldwing Trivia
Goldwing- The First 20 Years
From Japan to USA
Goldwing Magazine Articles
Two Wheel Magazine 1975- Honda's GL1000, The Future
Cycle Illustrated, Nov. 1975- 2 Big Ones From Honda
1977 Model GL1000 Setup Instructions
Owners Manuals
GL1000
1975 GL1000
1978 GL1000
GL1100
1980 GL1100 Standard
1981 GL1100 Interstate
1982 GL1100 Aspencade
1982 GL1100 Interstate
1982 GL1100 Standard
1983 GL1100 Aspencade
1983 GL1100 Interstate
GL1200
1984 GL1200 Standard
1986 GL1200 Interstate
1987 GL1200 Aspencade
GL1500
1987 GL1200 Aspencade
Service Bulletins and Recalls- All Models
GL1000
GL1000- Important GL1000 Service Reminder (1 Page) 6-13-1975
SL #108 Tire and Wheel Rim Matching Information 6-20-75 (7 pages)
Service Tools Newsletter 7-31-75 (2 pages)
SB 1000 #3 Pressurised Cooling System Tester 10-10-75 (3 pages)
SB 1000 #1 Cylinder Head Core Plug Leakage- Revised 7-9-76 (3 pages)
SL #117 Exhaust Pipe and Muffler Paint Damage 9-30-76 (1 page)
SL #118 Instrument Troubleshooting 10-27-76 (5 pages)
PB 1000-2 Changes to Clutch Components 11-3-76 (1 page)
PB 1000-3 Changes to Right Front Engine Cover 1-5-77 (1 page)
SB 1000 #11 Final Drive Gear Case Cover Change 10-15-77 (1 page)
SB 1000 #12 New Main Bearing Caps 11-23-77 (1 page)
SB 1000 #13 Recall to Replace Rear Brake Pads 3-21-78 (5 pages)
SB 1000 #14 Cylinder Head Bolt Torque Change 11-8-78 (1 page)
GL1200
Special Consumer Report: 1984 and 1985 GW Rear Hub
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Classic Goldwing Technical Forums
GL1200
GL1200 Engine Rebuild - Part 4 - Getting to the Road
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Classic Goldwings:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rednaxs60" data-source="post: 221021" data-attributes="member: 4617"><p>Was turning out to be a good day. Had the front fairing installed and the shelter. Looked like a road bike again. Turned on the key and it went through the required dash sequence as before, the dash lit up and all indicator lights for RPM, speed, gear, and such came on. Cruise and cruise set indicator lights are supposed to cycle but did not (a remnant from before the project), cruise set indicator light stayed on - this is new. Engine started, no dash indications, blank, nothing, zilch, nyet and a few other expletives. Signals work, have the taillight indicator on the dash, expected this because I changed all the bulbs to LED, need resistors in the circuit. Neutral light on as it should be, LED light is very nice. Cruise set indictor on, don't know why. </p><p></p><p>Since the engine started, no issue with the CFI system. Oil pressure light cycles when key turned on and no light when engine started, good. What I need is speed, RPM, oil and water temp. Did not do any shifting. </p><p></p><p>Installed the shelter, and all indicators work, but not displaying as expected. Plug/unplug connectors a couple of times and most fuel management indicators reset. The fuel quantity and range, displayed for a nanosecond so expect it is a connector issue. Did not test the system to determine if the dash would change from KPH to MPH, or the oil pressure and temp would display.</p><p></p><p>Checked the supplement for the '85 FI model. First check is battery voltage, but have been in this situation before with a low battery voltage.</p><p></p><p>Going to be a day or so of troubleshooting.</p></blockquote><p></p>
[QUOTE="Rednaxs60, post: 221021, member: 4617"] Was turning out to be a good day. Had the front fairing installed and the shelter. Looked like a road bike again. Turned on the key and it went through the required dash sequence as before, the dash lit up and all indicator lights for RPM, speed, gear, and such came on. Cruise and cruise set indicator lights are supposed to cycle but did not (a remnant from before the project), cruise set indicator light stayed on - this is new. Engine started, no dash indications, blank, nothing, zilch, nyet and a few other expletives. Signals work, have the taillight indicator on the dash, expected this because I changed all the bulbs to LED, need resistors in the circuit. Neutral light on as it should be, LED light is very nice. Cruise set indictor on, don't know why. Since the engine started, no issue with the CFI system. Oil pressure light cycles when key turned on and no light when engine started, good. What I need is speed, RPM, oil and water temp. Did not do any shifting. Installed the shelter, and all indicators work, but not displaying as expected. Plug/unplug connectors a couple of times and most fuel management indicators reset. The fuel quantity and range, displayed for a nanosecond so expect it is a connector issue. Did not test the system to determine if the dash would change from KPH to MPH, or the oil pressure and temp would display. Checked the supplement for the '85 FI model. First check is battery voltage, but have been in this situation before with a low battery voltage. Going to be a day or so of troubleshooting. [/QUOTE]
Insert quotes…
Verification
Post reply
Classic Goldwing Technical Forums
GL1200
GL1200 Engine Rebuild - Part 4 - Getting to the Road
Top