-
Service Bulletins and Recalls- All ModelsGL1000 GL1000- Important GL1000 Service Reminder (1 Page) 6-13-1975 SL #108 Tire and Wheel Rim Matching Information 6-20-75 (7 pages) Service Tools Newsletter 7-31-75 (2 pages) SB 1000 #3 Pressurised Cooling System Tester 10-10-75 (3 pages) SB 1000 #1 Cylinder Head Core Plug Leakage- Revised 7-9-76 (3 pages) SL #117 Exhaust Pipe and Muffler Paint Damage 9-30-76 (1 page) SL #118 Instrument Troubleshooting 10-27-76 (5 pages) PB 1000-2 Changes to Clutch Components 11-3-76 (1 page) PB 1000-3 Changes to Right Front Engine Cover 1-5-77 (1 page) SB 1000 #11 Final Drive Gear Case Cover Change 10-15-77 (1 page) SB 1000 #12 New Main Bearing Caps 11-23-77 (1 page) SB 1000 #13 Recall to Replace Rear Brake Pads 3-21-78 (5 pages) SB 1000 #14 Cylinder Head Bolt Torque Change 11-8-78 (1 page)
GL1200 Special Consumer Report: 1984 and 1985 GW Rear Hub
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Help Support Classic Goldwings:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Mill Fixture
I made this on the lathe but I use it on the mill. This will allow me to locate once so I can easily remove buttons a set at a time. I can clamp the caps down without damaging them by using the mounting holes just like the carb.