You can become a Supporting Member or just click here to donate.
slabghost":2385wfq2 said:Stripped down you could try to repair the crack. There is a type of rod that will solder aluminum. A propane torch will provide sufficient heat. If the crack does not reach the seat it may not be an issue at all. The line flange seals to the seat only.
dan filipi":1v740t78 said:Really? A crack?
In the housing?
Very unusual.
Not if water got in there and froze.dan filipi":2sqe4tt7 said:Really? A crack?
In the housing?
Very unusual.
mcgovern61":2t3pulm6 said:Not if water got in there and froze.dan filipi":2t3pulm6 said:Really? A crack?
In the housing?
Very unusual.
Steve83":1eduej60 said:Make sure you get the proper front calipers - they both use different piston sizes on the '83 since only one is used with the front master cylinder.
joedrum":a7zsefib said:they are with tweaking
Enter your email address to join: