yah man its looking good ...on this forum we make it ....good job backlander :music:
:smilie_happy: :smilie_happy: :smilie_happy: :smilie_happy: :yahoo: :yahoo: :yahoo:backlander":27pyde3r said:Thanks everyone for the compliments on the trailer. :thank_you: :blush: :headscratch: Now if I can just figure out how to get it out of the house. :doh: :smilie_happy: :smilie_happy: I knew there was something I was forgetting. :whistling:
backlander":wjcbb0yf said::builder: :heat: Got to many projects going on at one time. I finally found the material for the bumper I wanted, it's an aluminum running board from a Dodge Dakota p/u truck, used and might I add it was free :yahoo: Course it was filthy and stained from years of use but it cleaned up pretty good I think with a lot of elbow grease. Anyways, I plan to inset the lights in the middle wide space between the two rows of ridges, so I was wondering what you think would look best, make the bumper as wide as the frame, 40 inches or the same width as the fenders, about 52 inches. What cha think ?View attachment 3View attachment 2 Actualy it will ride a little bit higher than where it is in the pictures.
Enter your email address to join: