Recent content by traveler

*I used a length of PVC pipe, with notches cut for the caps, to give me enough leverage to compress the Progressive springs when re-installing the caps. Worked good to get the caps started, then finished with a wrench. Jim

the manifolds and carbs look great! What kind of a buffing machine and wheel did you use?

Mark, I have an 83 GL1100I and do not have to remove the guards to take of the valve covers. Perhaps your guards need to be adjusted just a bit, which would make the job easier next time. Fear not. Each task completed just makes us more competent to tackle the next. Jim

I noted that you are from So. Cal., so you may want to be prepared for when the hot top in parking lots gets too warm it gets soft and your side stand or center stand could sink. I use a simple square of aluminum, with a tether attached to remind me to retrive it before I drive off, to avoid...

Most of the Washington crowd have actually lost their marbles.

3400 rpm on my stock 83 Interstate puts me a bit over 65 mph in 5th gear on level highways. So you're getting great milage at a reasonable speed IMHO. Wind speed and direction does make quite a difference in MPG in my experience. Classics, especially when loaded with gear, are not that...

I read all the good posts about using a GEO Metro switch as a replacement. However, anyone got a tip on removing and replacing the switch without removing the grill/radiator? I can get at the switch by removing the right lower fairing, but don't think I'll be able to get a wrench on it. For...

Nice! A bit beyond what we did in the Experienced Rider's Course :Egyptian:

Nice looking trailer! It's going to hurt when you go through a toll both though $$

As noted above, I've had the same issue when getting it on a bit and not being precise. I have found that the oil I use appears to make a difference. I use Golden Spectro when I can find it, otherwise Shell Rotella. Jim

Excellent! A great perspective on life! Thanks for sharing. Jim

I've always used a Kryptonite lock which is big enough to go through the triangle molding on the front forks, where the brakes attach, and the front wheel. A cover will usually keep hands off when parked on a busy street.

There's no telling what can happen or when. Gotta stay in a state of grace just in case.

Good opportunity to try out my electrically heated vest and chaps.

:lol: 1) there's a place for such experiments, and the kitchen table is not one of them. 2) looks like he constrained the material in aluminum foil, thereby causing an increase in pressure and the resulting explosion. 3) minor candidate for the Darwinism award.