Search results

========================================= I'll get the stuff out soon and weigh it and all of the brackets and counter weight. My wing is veiwable by clicking this link. https://www.ngwclub.com/gallery/v/wingma ... ?g2_page=7

I have a Hondaline fairing and lowers with windshield and brackets for $150.00 color is wineberry.

I like your idea. I think that 4 equal length pivot brackets would be easy and adequate to fasten it forward or back. As far as a seat contact sunbob on this site. He is in Washinton.

============================================== The seat was built by Corbin and is listed for the GL1000. Had to make some brackets to clear the t-sigs. Other wise I would have drilled and tapped the frame.

----------------- I have a 79 CB750 CHROME fender on mine. But you can get raw fenders from Drag Specialties. Sportster style $50.00. Yes I have tried them.

Sweeeeeeeeet ride.

The gaskets are not formulated for synthetic products. The same with seals and O rings. Early Votec engines had a real problem with leaks when GM changed to the red or gold colored A/F. Cummins also had problems. They had to develope a steel/neopreme gasket for the enviromentally friendly A/F. I...

-------------------------------------------------------- Well to me it really doesn't sound serious. Get a bottle of Lucas fuel injector cleaner. Go to the gas station and put 1/2 the bottle in and top off with permium gas and ride it. You may feel a big improvement within 5 minutes. I did with...

The Honda gauge calibrations are at best not great. But chances are the fault lies with the sending unit. Try putting the 1100 sender in it.Also make sure you have green antifreeze zero silicate in the cooling system. If the antifreeze is not premixed then mix it to a 50-50 ratio. Too much...

I would like to find a GL1500 any model is fine, Old man crap broken-ok too. Registered miles 0 to 150,000 no problem. Major components must be good. 1: The engine and trans must run and not spew fluids. 2: The swing arm and drive hub must be road worthy and the rear wheel must not be damaged...

Colorite.com//This is the company that supplies all of the paint for all of the rice grinders we love so dearly. They have special kits with everything you need to paint your ride, even the sandpaper, instructions, and tac rag. Cost is 115.00 for a kit but have smaller and larger quanties. Seems...

_______________________________________________________________ Walnut basting media from Fastenal works really good. It will remove the paint without damaging the surface under the paint. That's what I use.

Just keep the wing that you have and get the younger brother.

I'D lke to take on of the 1500's and make it NAKED.

I would have opened a door on em.

I always liked that chocolate color, and that's as good as fresh out of the box.

I'll work on the turbo, You work on the juice, together we could BBQ the mo~~

You can get a Jardine or a MAC header system, and they work great without jetting.

++++++++++++++++++++++++++++++++++++++++++++++++++ Well howdy from Michigan, And to answer your question. In the 40+yrs of motorcycle repair the best carb cleaner I have ever found is the 5.5oz bottle of LUCAS injector cleaner. Put 1/2 bottle in the tank and top it off with premium gas and ride...

Oh By the way NO eq pipe, and runs better than new. Trust me 40+ yrs of working on bikes this is the best conversion I have ever seen.